![]() ![]() The new default with some Linux distirbutions (e. The following command will disable GUI on boot hence upon the reboot the system will boot into multi user target: $ sudo systemctl set-default multi-user Reboot or log out from a current session to exit GUI: $ gnome-session-quit How to enable GUI to start on boot.Both modes fail to work with framebuffer text mode, though. Needed on broken BIOS to make fan and temperature controls work. ![]() Also remove quiet to enable kernel startup messages. From: François Patte -Original Message- > From: ] On Behalf Of Koen Kooi > Sent: Monday, Janu7:14 PM > To: Tomi Valkeinen > Cc: linux- > Subject: Re: DSS: Series description > Op, om 12:47 heeft Tomi Valkeinen het volgende > geschreven. But if you can't even get into a console then this probably isn't the problem. It can be started on the command line with: Open your logo image and scale it to fit your frame buffer. If you do have a vga= option somewhere, you will need to remove it. lst and make sure the kernel arguments contain vga=normal instead of any other value. conf so that the line that says vga=normal instead of vga=746(or some other number) Rethinking this, I think it might be possible to pass vga=normal at boot time. ![]() 11 is selected on the left panel and then click the top-most option on the right panel. I'm assuming you're using Lilo to boot. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |